67 mustang with 302 motor and c4 transmission

Ford Mustang 1967 Description

this vehicle has a 68 302 motor. edelbrock 600 cfm carburetor. All new gaskets through out the engine (except the thermostat housing does leak even with a new gasket), ncluding new water pump, uel pump, il pump, ew fuel fines and filters, ew transmission lines. new radiator, ew gas tank, hrome oil dipstick and transmission dipstick, ew floor pans, ew trunk pans. engine runs good could probably use some tuning of the carb though. new flowtech headers all the rest of the exhaust though is missing.all new suspension shock and ball joints. disk brakes up front with new pads and rotors and has drums in the back with new rear brake lines. the bad, as a paint job that look ok but must have been done outside cause you can see spots of dirt in the paint( its not rust cause I sanded those spots off to make sure it was not rust). It needs a new trunk lid and a new hood as they have rust holes. drip rails have rusted through. needs new chrome to make show car quality. has good glass all around but needs new seals. needs a shifter and driveshaft to make it go and has 8 inch rear end. It has the seats but the interior is rough. it is rusty where top liner would go but not eaten all the way through bye any means I have a new liner as well. needs front and rear bumpers. I have the heater fan and core but they are not install.I have the windshield wiper motor but not installed eithers.has a brand new wiring harness kit from ez wiring with 21 circuit but needs to be installed as well.any other questions email me.