1967 ford mustang restoration

Ford Mustang 1967 Description

I am selling my 1967 mustang coupe project. I have invested a lot of time and money into this car. I need to sell car because of job relocation and lack of time to restore car. I am willing to make a deal on this but not give it away. Currently the motor, trans, and rear end have been rebuilt. The fuel tank and fuel pump are new. Motor is 289ci, Trans is manual 4 speed toploader 28 spline, Third member rear end is 8”. The car was factory A/C “california special” but I don’t have any of the under hood A/C parts, only the vent duct work and under dash parts. I started on the body work 80% down to bare metal so you can see there are only a couple places of small rust. Both front fenders are new, I have both new door skins, front and rear valance are new, front and rear bumpers are new. Front seats have been re foamed are covered(back has not). New drum brakes on front and rear. All wheel bearings have been replaced. Below is a list I put together of the parts that I’ve purchased. This is not a complete list too much to list. The car in its current state needs bodywork and paint then reassembled. This would make a good father son project or anyone else. Please only call if you are serious as this is a lot of info to discuss. I don’t need help selling the car and please no scams. Local pickup and I will help in any way I can. Call or text Peter 254-299-7259. Car is located in New Braunfels TX. Thanks

NEW PARTS

·Front to back metal fuel line

·Left outside remote mirror

·Instrument bezel lens set

·LH and RH outside door handle

·Rear end gasket

·6 piece sanding block set

·LH dynacorn door window regula

·1 gallon bondo

·Lower control arm assembly

·RH intermediate pipe

·Front valice

·Left and right doorskin

·Flow master dual exhaust

·Rear valice

·Front and rear bumper

·trunk weatherstrip

·Rear window weatherstrip

·Instrument bezel

·Mig stud welder dent puller

·Black valve covers

·Carburetor hardware

·K and N air filter and cover

·2 valve covers

·Dual 40 series flowmaster

·Exhaust clamps

·Tachometer

·Bumper bolt kit

·Ignition door trunk locks kit

·Door post seals

·Exhaust donut gasket

·Shift knob

·6 rear bumper bracket bolts

·Windshield weather stripping

·Quarter post seals

·Hood to cowl seal with fasteners

·Pair of door weatherstrip

·Rear view mirror

·Radio bezel without console

·Rear view mirror bracket

·2 panhead black screw

·2 front bumper bracket

·2 front bumper bracket

·2 rear bumper bracket

·LH bumper to fender bracket

·RH bumper to fender bracket

·3 Phillips pan head

·Black phillips oval head ts

·Electric radiator fan