79 Ford Bronco Ranger XLT

Ford Bronco 1979 Description

This is a 79 Bronco Ranger XLT that was a Arizona truck its entire life it has 87,800 original miles. It has a recent rebuilt 400 that the previous owner had done but no documentation with a Edelbrock intake and carburetor and a C6 transmission and a 205 part time 4x4 and has dual front shocks and sway bars front and rear. It has newer dual exhaust and brakes installed also. I just replaced the rear driveshaft U-joint to the axle and noticed the front driveshaft U-joint at the transfer case has a little movement and will need to be replaced sometime soon.The truck runs and drives fine i know the left front lockout is bad but the truck still goes into 4 wheel drive with the lockout not working correctly and have one to go with the truck and the starter i think needs replacing it makes some noise when turning over but it works fine to start the truck right now. I do autobody and painting for a living and and was looking for a super nice 78-79 Bronco to build into a show truck and it took me a couple years of searching to find this one because i know where to look for the bad rust areas on these and this truck is perfect absolutely zero rust just has a few normal smaller dings on it was never in any accidents from my thorough inspection of the body and frame. My plans have changed now and decided to sell this complete running and driving Bronco. This body and frame is completely rust free so if your looking for a super nice setup to do a build on this is the one for you! This truck was fitted with factory AC and heat from the factory but someone removed all the stuff under the hood and put a block off plate on the firewall and its missing a few pieces of duct work under the dash i believe also. It has factory cruise control but docent have the factory steering wheel. The interior is in decent shape and needs some things installed still but the front bucket seats were replaced with a new set of dark gray leather bucket seats out of a 2012 GMC Denali and the center console/3rd front jumper seat the rear bench seat is a factory unit still and if you didnt want these newer style bucket seats i do have a nice pair of tan front bucket seats and console out of a 80's Eddie Bauer Bronco i could throw in . I installed the factory chrome grill and i think i have a pair of the amber lights for in the fenders to go with the truck and i have the quarter panel mouldings that are not on in the pictures. A non-refundable deposit of $500 is due 48 hours after auction. If you have any question you can call or text Jon at 612-812-0523 I'm located in Apple Valley,MN 55124 buyer is responsible for pickup and I will assist if you go with a transport company and I have a good friend who works at a transport company I can set you up if needed. The Bronco is for sale locally and can be ended early